SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0
Pagina 9.6
9.1.13. MODIFIABLE TARGET FREQUENCIES
It is possible to enable or disable modification of the target heart rate during a constant heart rate
exercise. To change the selection, when the display shows the current setting:
HR : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
HR
MODIFIABLE <default>
NON MODIFIABLE
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.14. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the display shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter. If the ENTER key is pressed the display will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
9.1.15. FORMAT P&P KEY
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
display shows:
FORMAT P&P
Press ENTER to confirm. At the end of the formatting procedure, hold down the CLEAR key for a
few seconds to exit. The CLEAR key can be pressed at any time to interrupt the procedure and
revert to standby mode.
9.1.16. SN
This parameter shows the serial number of the machine.
SN:xxxxx
To Next Page
Loading...
