SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0
Page 9.11
9.2.10. EDIT CUSTOM MESSAGES
It is possible to modify the custom messages; press ENTER to invoke a submenu which displays
the first custom message, then use the +/- effort level keys to move to the other messages. Press the
ENTER key again to begin editing a message, or hold down the CLEAR key for a few seconds to
return to the upper menu level. While editing a message, move the cursor using +/- GOAL, select
the desired letter using the +/- effort level keys and use CLEAR to enter a blank space character.
Press ENTER to save the modified message, or hold down the CLEAR key to cancel and return to
the upper menu level.
9.2.11. CHANGE MESSAGGES LANGUAGES
It is also possible to display the custom standby messages in the language selected with the
preceding parameter. To extend the language setting to the predefined custom standby messages,
when the LED display is showing the current selection:
CHANGE MESS. LANGUAGE
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.2.12. ENABLE MULTI-LANGUAGE MODE
The machine can be configured to allow selection of the language at each session. To change the
selection, when the display shows the current setting:
LANGUAGE : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
LANGUAGE
FIXED <default>
OPTIONAL
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.2.13. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the display shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter. If the ENTER key is pressed the LED matrix will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
To Next Page
Loading...
