4-51
Group 12: Monitoring Parameters
Code Parameter Name Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
12-69
Accumulative Electricity Price
($)
0 ~ 9999 $ O O O
12-70
Accumulative Electricity Price
(10000$)
0 ~ 60000 $ O O O
12-71 Flow Meter Feedback 1 ~ 50000
GP
M
O O O
12-72 RTC Date 12.01.01 ~ 99.12.31
12.01.0
1
O O O
12-73 RTC Time 00:00 ~ 23:59 00:00 O O O
12-74 Operating Pressure Setting 0.01 ~ 25.50 2.00 PSI O X X
12-75 Pressure Feedback Value 0.01 ~ 25.50 - PSI O X X
12-76 Non-Load Voltage 0.0 ~ 600.0 - V X O X
12-77 Flow Meter Target Setting 1 ~ 50000 -
GP
M
O O O *7
12-78 Reserved
12-79 Pulse Input Percentage 0.0~100.0 - % O O O *7
12-81 Relay Card Display
ON: LCD display is 1
OFF: LCD display is 0
- - O O O
Note5
12-82 Motor Load 0 ~ 200.0 - % O O O
Note6
12-85 AI3 Input
Display the current Al3 input
(-10V corresponds to -100%, 10V
corresponds to 100%)
- % O O O *10
* Models of inverter ratings above 200V 60HP (including 60HP) and 400V 100HP (including 100HP) in
IP20 enclosure do not support functions of heatsink temperature display. All models in IP55
enclosure support functions of heatsink temperature display.
* Maximum upper limit in motor speed (rpm) of parameter 12-22 is 65534
Group 13 Maintenance Function Group
Code Parameter Name Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
13-00 Inverter Rating Selection 00H~FFH - - O O O *4
13-01 Software Version 0.00-9.99 - - O O O *4
13-02
Clear Cumulative Operation
Hours Function
0: Disable to Clear Cumulative
Operation Hours
1: Clear Cumulative Operation
Hours
0
O O O *1
13-03 Cumulative Operation Hours 1 0~23 - hr O O O *4
13-04 Cumulative Operation Hours 2 0~65534 - day O O O *4
13-05
Selection of Accumulative
Operation Time
0: Accumulative time in power on
0
O O O *1
1: Accumulative time in operation
13-06 Parameters Locked
0: Only parameter 13-06 and
frequency setting parameters in
main screen are writable
2 O O O *1
1: Only user parameter is enabled.
2: All parameters are writable.
To Next Page
Loading...
