TECO F510 series - Page 174

4-85
Example 1: Set 03-00 (Multi-function terminal Function Setting-S1) to user parameter 0 (00-41)
Steps LCD Display Descriptions
1 Select the start parameter group (00) in the advanced modes.
2
PARA 00
-41. User P0
-42. User P1
-43. User P2
Press (READ/ ENTER) key and ▲ (Up) / ▼ (Down) to select user
parameter 0 (00-41).
3
Edit 00-41
User P0=00-41
00-41 User P0
<00-01 - 24-07>
Press (READ/ ENTER) key to the screen of data setting/ read.
* The selected setting value will flash.
4
Edit 00-41
User P0=00-41
03-00 S1 Function Sel
<00-01 - 24-07>
Press ◄ (Left) / ► (Right) and ▲ (Up) / ▼ (Down) key to set the
value to 03-00 ( Multi-function terminal Function Setting-S1)
5
Edit 00-41
User P0= 03-00
03-00
S1 Function Sel
<00-01 - 24-07>
Press (READ/ ENTER) key to save 03-00 and the digit stops
flashing
and the screen displays User P0 = 03-00; 03-00
(Multi-function terminal Function Setting-S1) has been defined as
00-41. Few seconds later, the selected digit will flash again.
6
Monitor
Freq Ref
12-16=000.00Hz
---------------------------------------
12-17=000.00Hz
12-18=0000.0A
Press (DSP/ FUN) key to the display of main screen.
* If users do not press BACK key in one minute, the screen will
automatically display the monitor mode shown as the left figure. The
automatically return time can be set via 16-06.
Group
00 Basic Func.
01 V/F Pattern
02 Motor Parameter