TECO F510 series - Page 173

4-84
 User Parameter Setting (00-41 ~ 00-56) (only for LCD )
00- 41
User Parameter 0 Function Setting
00- 42
User Parameter 1 Function Setting
00- 43
User Parameter 2 Function Setting
00- 44
User Parameter 3 Function Setting
00- 45
User Parameter 4 Function Setting
00- 46
User Parameter 5 Function Setting
00- 47
User Parameter 6 Function Setting
00- 48
User Parameter 7 Function Setting
00- 48
User Parameter 8 Function Setting
00- 50
User Parameter 9 Function Setting
00- 51
User Parameter 10 Function Setting
00- 52
User Parameter 11 Function Setting
00- 53
User Parameter 12 Function Setting
00- 54
User Parameter 13 Function Setting
00- 55
User Parameter 14 Function Setting
00- 56
User Parameter 15 Function Setting
‧ User parameter (00-41 ~ 00-56) can select 16 sets of parameters (group 00 ~ 24, but except 00-00/
00-41~00-56/ group 17) and put them into the list to do the fast access setting.
‧ When the access setting of parameter 13-06 is set to 1, user parameter 00-41 ~ 00-56 can be
displayed and changed.
‧ User parameter 00-41 ~ 00-56 can be changed in the advanced modes, exclusive of being in
operation.
‧ Set value in the parameter of 00-41 ~ 00-56 and set 13-06 to 1.
‧ When 13-06=1, only parameter of 00-00 ~ 00-56 can be set or read in the advanced modes. 13-06=1
is enabled in the parameter setting of 00-41~00-56.
‧ When user would like to leave the screen of user parameters, press RESET key and then DSP/FUN
key to select parameter Group 13.