4-83
00- 33
Modified Parameters
Range
【0】:
Disable
【1】: Enable
Note: only for LCD keypad.
This parameter automatically lists all the adjusted parameters. When the default value is adjusted and
00-33=1, it will list all the parameters different from default values in the advanced modes and these
parameters can be edited directly. The adjusted parameters list displays only when 00-33 is set from 0 to 1
or 00-33=1 at start up.
If user wants to restore to the original editing interface, it is only required to set parameter 00-33=0.
This function can display 250 adjusted parameters. If they are more than 250 parameters, it will list the
adjusted parameters before 250.
Example: set 00-03 (Alternative Run Command Source Selection) to be different default value.
Steps LCD Display Descriptions
1
The starting parameter group (00) in the setting modes of ▲ (Up)/
▼ (Down) selection groups.
2
PARA 00
-01. Motor Direction
-02. RUN Source
-03. Sub RUN Source
Press READ/ ENTER key and ▲ (Up)/ ▼ (Down) to select
alternative run command source (00-03).
3
Edit 00-00
Sub RUN Source
1 Terminal
(0 ~4)
<2>
Press READ/ ENTER key and adjust the value. The selected setting
value will flash.
4
PARA 00
-33. Modify parameter
-41. User P1
-42. User P2
Press DSP/ FUN to the menu of modified parameters (00-33).
5
Edit 00-33
Modify parameter
1 Enable
(0 ~1)
<0>
Press READ/ ENTER key to adjust the value to 1 (The modified
parameter is enabled.) The selected setting value will flash.
6
Modify 00
00-03. Sub RUN Source
00-33. Modify parameter
Press DSP/ FUN back to the advanced modes.
Group
00 Basic Func.
01 V/F Pattern
02 Motor Parameter
To Next Page
Loading...
