TECO F510 series - Page 310

4-221
12- 05
Status Display of Digital Input Terminal (LED/LCD)
Range
Read-only
Terminals S1-S6 are represented using two segments of each digit. Segment turns on when input is active.
The bottom segments of each of the first three digits are used to represent the digital outputs (R1, R2, R3).
Segments turn on when output is active.
When operation command is changed to PLC, press RUN key and it will light up.
Example1: S1~S6, R1, R2 and R3 are ON
Example2: S1~S6, R1, R2 and R3 are OFF
Input Terminal(S6)
Input Terminal(S5)
Input Terminal(S4)
Input Terminal(S3)
Input Terminal(S2)
Input Terminal(S1)
0：OPEN
1：CLOSE
Output Terminal(R3)
Output Terminal(R2)
Output Terminal(R1)
0000 00000