TECO F510 series - Page 319

4
-230
13- 12
Option Card Id *1
Range
【0~255】
This parameter displays option card Id on the control board and it is enabled only with the option card.
【
0】: None
【8】: IO-8DO
13- 13
Option Card CPLD Ver. *1
Range
【0.00~9.99】
*1: It is new added in inverter software V1.4.
This parameter displays option card CPLD version on the control board and it is enabled only with option
card.
13- 14
Fault Storage Selection
Range
【0】:
Auto Restart Fault Messages are not saved in fault history during Auto-Restart.
【1】:
Auto Restart Fault Messages are saved in fault history during Auto-Restart.
13-14=0,
Fault messages are not saved in fault history (12-46~12-49 & 13-21~13-50) during the process when auto
restart function is active.
13-14=1,
Fault messages are saved in fault history (12-46~12-49 & 13-21~13-50) during the process when auto
restart function is active.
Note: Parameters 13-21~13-50 are 30 Fault History: When it detect fault, inverter will store to fault history.
If the fault occurs again, parameter 13-21 will change to parameter 13-22.