TECO F510 series - Page 327

4-238
Monitor 00:00
Freq Ref
12-16 = 000.00 Hz
12-17 = 000.00 Hz
12-18 = 0000.0A
16- 09
Selection of Operator Removed (LCD)
Range
【
0】: Keep operating when LCD operator is removed.
【1】: Display fault to stop when LCD operator is removed
16-09=0: Continue operating when keypad is removed.
16-09=1: Trip inverter when keypad is removed while operating in local mode.
16- 10
RTC Time Display Setting
Range
【
0】: Hide
【1】: Display
16- 11
RTC Date Setting
Range
【12.01.01 ~ 99.12.31】
16- 12
RTC Time Setting
Range
【00:00 ~ 23:59】
Set the internal clock before using the function of Real Time Clock (RTC).
RTC date setting is determined by parameter 16-11 and RTC time setting is determined by parameter
16-12.
RTC is displayed in the top of the keypad and refer to Fig.4.4.85 for the selection of RTC time display
(16-10) is set to 1.
Figure 4.4.85 RTC Time Display (Example)
Notes:
- RTC is not enabled if keypad does not connect with the inverter.
- The counting time continues running regardless of the function being hide or display in the
paramerer 16-10 (RTC Time Display Setting).
Users can apply the parameters 12-72 and 12-73 to monitor the specific RTC date and time.
RTC has the following characteristics:
- Four times a day
- Four weeks
- Timer offset function (preset time)
- Timrer enables via multi-function digital input
- Selection for contant time and speed
- Timer enables multi-function digital output