TECO F510 series - Page 326

4-237
Steps LCD Display (English) Description
5
 Use Read / Enter key to enable the read operation, the display is
shown as the left.
 The bottom of LCD display will show a bar to indicate the read
progress.
6
“WRITE COMPLETE” will be displayed on the keypad when writing
was successful.
 Until the subsequent display of "SysInit", please power off and
restart.
 The error message of “WRE Write Error " may occur on the
keypad when writing parameters to the inverter is prohibited.
 If the error is displayed, press any key to remove the error
message and go back to parameter 16-07.
7
When DSP/FUN key is pressed, the display returns to parameter
16-07.
 Verify: Compare Inverter Parameters against Keypad Parameters.
Steps LCD Display (English) Description
1
Group
14 PLC Setting
15 PLC Monitor
16 LCD Keypad Func.
Select the copy function group (16) from the group menu.
2
Press the Read / Enter key and select parameter (16-07) copy sel.
3
Press the Read / Enter key to display the data setting / read screen
(LCD display is inversed).
4
Change the set value to 3 (verify) by using the up arrow key.
5
 Use Read / Enter key to enable the read operation, the display is
shown as the left.
 The bottom of LCD display will show a bar to indicate the read
progress.
6
“VERIFY COMPLETE” will be displayed on the keypad when writing
was successful.
 The error message of “VRYE Verify Error " may occur on the
keypad when writing parameters to the inverter is prohibited.
 If the error is displayed, press any key to remove the error
message and go back to parameter 16-07.
7
When DSP/FUN key is pressed, the display returns to parameter
16-07.