TECO F510 series - Page 325

4-236

READ：Copy inverter parameters to the keypad
Steps LCD Display (English) Description
1
Group
14 PLC Setting
15 PLC Monitor
16 LCD Keypad Func.
Select the copy function group (16) from the group menu.
2
Press the Read / Enter key and select parameter (16-07) copy sel.
3
Press the Read / Enter key to display the data setting / read screen
(LCD display is inversed).
4
Change the set value to 1 (read) by using the up arrow key.
5
 Use Read / Enter key to enable the read operation, the display is
shown as the left.
 The bottom of LCD display will show a bar to indicate the read
progress s.
6
“READ COMPLETE” will be displayed on the keypad when reading
was successful.
 The error message of "RDP Read Prohibited" may occur on the
keypad when reading parameters from the inverter is prohibited.
 If the error is displayed, press any key to remove the error
message and go back to parameter 16-07.
7
When DSP/FUN key is pressed, the display returns to parameter
16-07.
 WRITE: Copy Keypad parameters to the Inverter
Steps LCD Display (English) Description
1
Group
14 PLC Setting
15 PLC Monitor
16 LCD Keypad Func.
Select the copy function group (16) from the group menu.
2
Press the Read / Enter key and select parameter (16-07) copy sel.
3
Press the Read / Enter key to display the data setting / read screen
(LCD display is inversed).
4 Change the set value to 2 (write) by using the up arrow key.