4200A-SCS Parameter Analyzer User's Manual Section 7: Make C-V measurements on a MOSCAP
4200A-900-01 Rev. D/April 2020 7-13
6. Make sure that the probes have been disconnected from the DUT, then select OK. The
compensation runs, and a dialog box confirms that the compensation has run successfully.
7. Select Exit to close the Tools dialog box.
8. From the Terminal Settings pane, enable corrections by selecting the Open checkbox.
Figure 99: Enabling CVU Compensation
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
