Tektronix Keithley 4200A-SCS - Update the Switch Configuration in Kcon

Section 5: Configure and use a Series 700 Switching System 4200A-SCS Parameter Analyzer User's Manual
5-6 4200A-900-01 Rev. D/April 2020
Update the switch configuration in KCon
After completing the switch and device connections, use KCon to manage the configuration of all
instrumentation controlled by the 4200A-SCS software. You use KCon to:
• Add the switching system to the 4200A-SCS configuration
• Add the test fixture to the system configuration
• Configure the test fixture
• Add a matrix card to the switching system
• Configure the matrix card connections
To add a switching system to the 4200A-SCS configuration:
1. From the desktop, open the KCon application.
2. In the bottom left of the KCon window, select Add External Instrument.
3. Select your switching system. The Series 700 Switching Systems are highlighted in the next
figure.
Figure 55: Add External Instrument box, Series 700 Switching Systems highlighted
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com