4200A-SCS Parameter Analyzer User's Manual Section 4: Use the RPM to switch the SMU, CVU, and PMU
4200A-900-01 Rev. D/April 2020 4-15
Configure the pulse-diode test
To configure the pulse-diode test:
1. In the project tree, select the pulse-diode test.
2. From the Key Parameters pane, change the Cathode terminal setting from PMU1-GND to
PMU1-2, as shown in the following figure.
3. Adjust the pulse operation as needed.
Figure 46: Key Parameters pane for the pulse-diode test
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
