Tektronix Keithley 4200A-SCS - Set up the Measurements in Clarius; Search for and Select a Project

Section 7: Make C-V measurements on a MOSCAP 4200A-SCS Parameter Analyzer User's Manual
7-4 4200A-900-01 Rev. D/April 2020
Set up the measurements in Clarius
This section describes how to set up the Clarius application to make a C-V sweep on a MOS
capacitor. You select an existing project from the project library and configure a C-V sweep test.
For this example, you will use Clarius to:
• Search for and select a project in the Project Library
• Configure the test
• Perform offset compensation
• Run the test
• View and analyze the test results
Search for and select a project
1. Choose Select.
Figure 87: Select highlighted
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com