Section 6: Make I-V measurements on a solar cell 4200A-SCS Parameter Analyzer User's Manual
6-6 4200A-900-01 Rev. D/April 2020
Configure the test
To configure the test:
1. Select the fwd-ivsweep solar cell I-V test in the project tree.
2. Select Configure.
Figure 78: Configure highlighted
3. Adjust the Anode settings as needed.
Figure 79: Key Parameters pane for the I-V sweep of a solar cell
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
