4200A-SCS Parameter Analyzer User's Manual Section 1: Introduction
4200A-900-01 Rev. D/April 2020 1-3
Application examples
This manual provides application examples that show you how to perform tests from the front panel
and over a remote interface. The applications include:
• Create a new project and test (on page 3-1)
• Use the RPM to switch the SMU, CVU, and PMU (on page 4-1)
• Configure and use a Series 700 Switching System (on page 5-1)
• Make I-V measurements on a solar cell (on page 6-1)
• Make C-V measurements on a MOSCAP (on page 7-1)
• Use the 4200A-CVIV Multi-Switch (on page 8-1)
• PMU for pulsed I-V measurements on a MOSFET (on page 9-1)
The default settings used for the devices, tests, and projects in Clarius are generally sufficient to
produce usable data when executing a test. However, you may have additional settings you want to
apply when you configure your measurements.
General ratings
The general ratings and connections of the 4200A-SCS instrument are listed in the following table.
100 V
RMS
to 240 V
RMS
, 50 Hz or 60 Hz
Input and output connections
See Front panel overview (on page 2-1) and Rear panel overview (on
page 2-4).
For indoor use only
Temperature range:
Operating: 10 °C to 40 °C (50 °F to 104 °F)
Storage: −15 °C to 60 °C (5 °F to 140 °F)
Humidity range:
Operating: 5% to 80% relative humidity, non-condensing
Storage: 5% to 90% relative humidity, non-condensing
Altitude
Operating: 0 to 2000 m (0 to 6562 ft)
Storage: 0 to 4600 m (0 to 15092 ft)
Pollution degree: 1 or 2
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
