Tektronix Keithley 4200A-SCS - Create a New Project and Test; Introduction; Equipment Required

In this section:
Introduction .............................................................................. 3-1
Equipment required .................................................................. 3-1
Device connections .................................................................. 3-2
Set up the measurements in Clarius ........................................ 3-3
Introduction
This section provides an example of how to create a new blank project and configure a new blank test.
You will create a test to be performed on a MOSFET, but the procedure is general and can be applied
to different devices and applications.
The default settings used for the devices, tests, and projects in Clarius are generally sufficient to
produce usable data when executing a test. However, you may have additional settings you want to
apply when you configure your measurements.
Equipment required
• One 4200A-SCS, with the following instruments:
▪ Two medium power (420x-SMU) or high power (42x1-SMU) SMUs
▪ Two 4200-PAs
• Three 4200-TRX-2 or 4200-MTRX-2 triaxial cables (supplied with SMU)
• One shielded, three-terminal test fixture with triaxial inputs (such as the 8101-PIV)
Section 3
Create a new project and test
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com