Other search types
Bus Search configuration menus on page 230
Edge Search configuration menu on page 250
Logic search configuration menu on page 251
Pulse Width Search configuration menu on page 253
Rise/Fall Time Search configuration menu on page 255
Runt Search configuration menu on page 257
Setup and Hold Search configuration menu on page 258
Timeout Search configuration menu on page 260
Window Search configuration menu on page 262
Bus Search configuration menus
Use a Bus search to search for and mark bus-related events (Start, Stop, Missing Acq, Address, Data, and so on) on a bus
waveform.
To create a new Bus search:
1. Tap Add New... Search.
2. Set the Search Type to Bus.
3. Select the bus Source.
4. Use the search menu fields to set the search parameters.
To change the settings of an existing search, double-tap the search badge to open its configuration menu and make necessary
changes.
Select a link to view the configuration menu settings for a specific bus.
ARINC 429 serial bus search configuration menu on page 231
Audio serial bus search configuration menu on page 233
CAN serial bus search configuration menu on page 234
Ethernet serial bus search configuration menu on page 235
FlexRay serial bus search configuration menu on page 237
I2C serial bus search configuration menu on page 239
LIN serial bus search configuration menu on page 240
MIL-STD-1553 serial bus search configuration menu on page 241
Parallel bus search configuration menu on page 243
RS-232 serial bus search configuration menu on page 243
SENT serial bus search configuration menu on page 244
SPI serial bus search configuration menu on page 246
SPMI serial bus search configuration menu on page 247
USB serial bus search configuration menu on page 248
Menus and dialog boxes
230 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
