Oscilloscope R eference MyScope controls
Behavior
This measurement is the amount of time one waveform leads or lags another waveform. Phase is expressed
in degrees, where 360° comprise one waveform cycle. The measurement is taken at the voltage level
specified by the Mid Reference control.
What do you want to do next?
Learn about taking amplitude measurements. (see page 270)
Learn about taking timing measurements. (see page 273)
Learn about taking histogram measurements. (see page 290)
Learn abou
t taking communications measurements.
(see page 278)
Learn more about the Measurements List. (see page 870)
Mid referen ce
The Mid r
eference defines the middle reference level of a waveform; the default level is 50%. This
reference value is primarily used for making measurements between edges such as pulse widths. To
change this level, click the control, and then set the level with the multipurpose knob.
MyScope controls
Click one of links below to access detailed information on the controls in each category:
File (see page 534)
Edit (see page 513)
Vertical (see page 481)
Horizontal (see page 177)
Trigger (see page 385)
Display (see page 163)
Cursors (see page 71)
Measure (see page 268)
Mask (see page 209)
Math (see page 241)
Utilities (see page 933)
NOTE. Some MyScope controls operate differently than the identical control in the user interface.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 889
To Next Page
Loading...
Need help?
General
