Tektronix TDS5054B

149
XYZ format channel assignments
When you use the XYZ display format, channel waveforms are assigned to the axis indicated in
the following table. You cannot display math and reference waveforms in the XYZ format.
Channels X Axis Y Axis Z Axis
Ch 1, Ch 2, and Ch
3
Ch 1 Ch 2 Ch 3
If you only display one or two source channels when you enter XYZ format, the instrument
automatically turns on the other channels.
Note
The XYZ format is only available on 4-channel models and is only supported in FastAcq mode.