Analyze Waveforms
: Rise time cursor
: Fall time cursor
3. Press the function key under the MOVE menu item to highlight the upper
cursor (if it is not already highlighted).
4. Use the up a
nd down arrow keys to position the upper cursor.
5. Press the function key under the MOVE menu item to highlight the lower
cursor.
6. Use the up and down arrow keys to position the lower cursor.
NOTE. Ev
en when the key labels are not displayed at the bottom of the screen,
you still can use the arrow keys. This allows full control of both cursors while
having a full screen view.
7. Use the cursors to measure the amplitude, h igh or low value, or overshoot
of the waveform.
This screen shows the voltage difference betw een the two cursors and the voltage
at the cursors. (See Figure 28.)
Figure 28: Voltage measurement with horizontal cursors
THS3000 Series Oscilloscopes User Manual 55
To Next Page
Loading...
