Televic TCS5500 - Adjusting Microphone Settings; Initializing Conference Units

TCS5500
Page | 57
Changing the delegate microphone settings
The audio settings of the delegate microphone can be changed if
for instance the gain is to high (with Larsen as effect) when
multiple microphones are activated.
The automatic gain reduction setting of the conference units can be
changed by following the next sequence of steps.
 Press ENTER, choose Conference. Press ENTER again, now
choose Micro. Press ENTER and choose Aut. Gain Red.. Press
ENTER and turn the wheel to set the gain reduction to the
desired value. Press ENTER to save the adjusted gain reduction
level.
Changing the maximum number of microphones which
may be active simultaneously
Press ENTER, choose Conference. Press ENTER again, now
choose Max # Microphones. Press ENTER. Turn the wheel to alter
the maximum number of microphones. Press ENTER to save your
settings.
Initializing the conference units
There are 2 options during the initialization, an automatic and a
manual initialization. In most of the cases an automatic
initialization will suffice. The manual initialization is most handy
when you want the delegate units numbered in a desired sequence.
The automatic initialization is self-explanatory; to initiate it,
execute the following sequence.
 Press ENTER, choose Conference. Press ENTER again, now
choose Initialize Units. Press ENTER, choose Automatic Init.
Press ENTER. Wait until the menu displays the number of
microphones found and the number of the microphone that is
assigned as president microphone, then press EXIT.
 The manual init consists out of four parts. We have a Full Init,
an Add Unit and a Delete Unit menu choice. The purpose of
these menu choices has been explained above. The steps which
need to be taken are similar to the example given below.
 To manually initialize the conference units execute the
following sequence: Press ENTER, choose Conference. Press
ENTER again, now choose Initialize Units. Press ENTER,
choose Manual Init. Press ENTER and choose Full Init. Press
ENTER. The red signal rings of the conference units will start
flashing. Press the MICRO button of the conference units in any
sequence you desire. After pressing the MICRO button the red
signal ring stops flashing and the green LED switches on as