Page | 84
The slave microphone panel must be connected to the INT5500
port number of the first microphone plus 1 (2 or 4).
A mix of DML5500/DML5500-slave microphones and normal
CML/DML5500 microphones on the same INT5500 is possible as
long as the first two points are respected.
LS5500 loudspeakers must be connected to the corresponding
DCS-ports and will be muted together if one of the two DML5500/
DML5500-slave microphones is switched on.
The DML5500/DML5500-slave microphones have no chairman
functionality.
Some valid configurations are:
To Next Page
Loading...
