Tenda MX3 - Page 105

Document version: V1.0
95
The following table describes the parameters displayed on this page.
Parameter description
Parameter
Description
Multicast
Used to enable or disable the multicast function.
STB
Used to enable or disable the IPTV function of the Mesh device.
When this function is enabled, the port LAN3/IPTV (MX6/EX6/MX12/EX12) or LAN
(MX3/EX3) can be used only as an IPTV port and be connected to an IPTV set-top box.
VLAN
Specifies the VLAN ID of your IPTV service. It is required when STB is enabled.
−
If your ISP does not provide any VLAN ID information when the IPTV service is
available, keep Default.
−
If you have obtained the VLAN ID from your ISP when the IPTV service is available,
choose Custom VLAN and enter the VLAN value.
Ethernet Port
Selection
Specifies the IPTV port. It is required when STB is enabled.
This parameter is available only for MX15 Pro/EX15 Pro/Mesh15XP/MX21 Pro/EX21
Pro/Mesh21XEP.
Watch IPTV programs through the Mesh device
Scenario: The IPTV service is included in your broadband service. You have obtained the IPTV
account and password from your ISP, but no VLAN information.
Goal: Watch IPTV programs through the Mesh device.