Tenda MX3 - Quick setup

Document version: V1.0
10
2.1 Quick setup
The device kit you purchased includes multiple devices. You can choose one of them to work as the
primary node and others as the secondary nodes to extend your network. This section describes
how to connect the devices and enable internet access through the quick setup wizard. It contains
the following sections:
−
Connect your primary node
−
Connect your primary node to the internet
−
Extend your network
2.1.1 Connect your primary node
Connect your primary node with a modem
To connect your primary node with a modem:
Step 1
Power off your modem.
Step 2
Use the included Ethernet cable to connect the WAN port of the primary node to your
modem.
The WAN port of the primary node may vary with models.
−
For MX3/EX3, connect to the WAN/LAN port.
−
For MX6/EX6/MX12/EX12, connect to the WAN/LAN1 port.
−
For MX15 Pro/EX15 Pro/MX21 Pro/EX21 Pro, connect to any of 1, 2 and 3 ports.
Step 3
Power on your modem.
Step 4
Power on the primary node, and wait until the LED indicator blinks green.
---End