4.5
Internet settings
By configuring the internet settings, you can achieve shared internet access (IPv4) for multiple
users within the LAN.
If you are configuring the Mesh device for the first time or after restoring it to factory settings,
refer to Connect your primary node to the internet to configure the internet access. After that, you
can change the internet settings by following the instructions in this chapter.
This section includes the following parts:
−
Overview
−
Access the internet with a PPPoE account
−
Access the internet through a dynamic IP address
−
Access the internet with a set of static IP address information
−
Set up dual access connection
4.5.1
Overview
Parameters for internet access are provided by your ISP. Contact your ISP for any doubt.
To access the internet settings page, log in to the web UI (mobile client), and tap Internet Settings.
The following table describes the parameters displayed on this page.
To Next Page
Loading...
