3.6.17
WPS
The WPS function enables WiFi-enabled devices, such as smartphones, to connect to Wi-Fi
networks of the Mesh device without entering the password.
−
This function only applies to WPS-enabled Wi-Fi devices. It is enabled by default and cannot be
disabled.
−
Wi-Fi networks encrypted with WPA3 cannot be connected through WPS.
−
The WPS negotiation times out in 120 seconds. The WPS button is disabled during WPS
negotiation.
To connect a device to the Wi-Fi network using the WPS function:
Step 1
Run the Tenda WiFi App, and choose Settings > Advanced > WPS.
Step 2
Tap the WPS button on the row where the target node resides.
Countdown starts when the WPS function is enabled.
Step 3
Enable the WPS function on the WPS-supported device within 2 minutes to start WPS
negotiation.
---End
Now the WPS-supported device is connected to the internet.
To Next Page
Loading...
