3.6.1
Internet settings
Generally, you can complete the internet settings by following the quick setup wizard of the Tenda
WiFi App when you set the nodes for the first time. If your internet connection type or parameters
changed, you can set them here again to enable your nodes to access the internet. The nodes
support the following connection types:
−
PPPoE: If this type is selected, you need to enter the PPPoE user name and password
provided by your ISP for internet access.
−
Dynamic IP: If this type is selected, no parameter is required. The node obtains the
dynamic IP address and other related parameters automatically from your ISP.
−
Static IP: If this type is selected, you need to enter the static IP address and other
related parameters provided by your ISP for internet access.
The following three connection types are available only when you select Russia in Special ISP
Settings.
−
Russia PPPoE: If this type is selected, you need to enter the PPPoE user name, PPPoE
password, service name, server name, MTU value, and IP address information (if any)
provided by your ISP for internet access.
−
Russia PPTP: If this type is selected, you need to enter the IP address, user name and
password of the PPTP server, MTU value, and IP address information (if any) provided
by your ISP for internet access.
−
Russia L2TP: If this type is selected, you need to enter the IP address, user name and
password of the L2TP server, MTU value, and IP address information (if any) provided
by your ISP for internet access.
Set up a PPPoE connection
Configuration procedure:
Step 1
Run the Tenda WiFi App, and choose Settings > Internet Settings.
Step 2
Tap Internet Connection Type.
Step 3
Select PPPoE and tap Next.
Step 4
Enter the PPPoE user name and password provided by your ISP.
To Next Page
Loading...
