3.7.2
Auto system maintenance
This function reboots the Mesh devices regularly to keep them in the best working condition. You
can set up the auto system maintenance function here:
Configuration procedure:
Step 1
Run the Tenda WiFi App, and choose Settings > Auto System Maintenance.
Step 2
Enable Auto System Maintenance.
Step 3
Select a reboot time for Reboot at.
You are recommended to set a time when your network is idle. 02:00 is used as an
example.
Step 4
Select the days on which the rule takes effect.
Step 5
Enable or disable the Delay Reboot function as required.
Step 6
Tap Save.
---End
Now the devices will automatically reboot at the specified time.
If the devices are exchanging data and the traffic
is greater than 3 KB/s, the devices will not reboot
at the specified time even when the Delay
Reboot function is enabled. Within 2 hours after
the specified reboot time, the devices keep
detecting the traffic, and reboot once when the
traffic is lower than 3 KB/s for 0.5h. Otherwise,
the devices will reboot the next day at the
specified reboot time.
To Next Page
Loading...
