Tenda MX3 - Network Status

Document version: V1.0
20
2.3 Network status
This module allows you to view basic network information, including controller and agent
information, and perform quick setup on nodes, such as adding a node, one-click optimization,
rebooting all nodes, and turning on/off all indicators.
This section includes the following parts:
−
Network status
−
Network topology
2.3.1 Network status
To view the network status:
Step 1
Log in to the web UI.
Step 2
Choose Network Status.
The following page is displayed.
---End
The following table describes the information displayed under Network Status.
No.
Description
1
Indicates the internet connection status.
−
Connected: The primary node is connected to the internet successfully.
−
Disconnected: The primary node is disconnected from the internet.
2
The information here varies depending on the internet connection status.
−
X.xx Mbps: The internet is connected successfully, and the real-time upload and
download speeds are displayed, as shown in the figure above.
−
Connecting: The primary node is connecting to the internet.
−
Other information (for example, No Ethernet cable is connected to the WAN port): The
internet connection failed. Click the prompt message to view tips for troubleshooting. If
the problem persists, contact technical support for help.