3.6.16
MESH button
You can use the MESH button to network your Tenda devices that support the Mesh function. On
this page, you can enable or disable the MESH button as required.
−
For information security, do not enable MESH Button when using the Mesh device in public
areas.
−
With this function disabled, you cannot form a network by using the MESH button on the device.
However, you can use the Tenda WiFi App or web UI to add the device to a network.
The Mesh device supports three methods for mesh networking:
−
Method 1: Press the MESH button for about 1 to 3 seconds. The LED indicator blinks
green fast, which indicates the device is searching for another device to form a
network. Within 2 minutes, press the Mesh button of another device for 1 to 3
seconds to negotiate with this device.
−
Method 2: Run the Tenda WiFi App and manage the network, tap on My WiFi
page, and follow the on-screen instructions.
−
Method 3: Log in to web UI of the node, click on Network Status page, and
follow the on-screen instructions.
To enable or disable the MESH button:
Step 1
Run the Tenda WiFi App, and choose Settings > Advanced > MESH Button.
Step 2
Enable or disable the MESH Button function as required.
---End
To Next Page
Loading...
