Tenda MX3 - Ipv6

Document version: V1.0
183
3.6.10 IPv6
This function is only available in the router mode.
This Mesh device supports IPv4 and IPv6 dual-stack protocols. In the IPv6 part, you can:
−
Perform IPv6 WAN settings
−
Change IPv6 LAN settings
IPv6 WAN settings
The Mesh device can access the IPv6 network of ISPs through three connection types. Choose the
connection type by referring to the following chart.
Scenario
Connection Type
−
The ISP does not provide any PPPoEv6 user name and password and
information about the IPv6 address.
−
You have a router that can access the IPv6 network.
DHCPv6
IPv6 service is included in the PPPoE user name and password.
PPPoEv6
The ISP provides you with a set of information including IPv6 address, subnet mask,
default gateway and DNS server.
Static IPv6 address
Before configuring the IPv6 function, ensure that you are within the coverage of the IPv6 network and
already subscribe to the IPv6 internet service. Contact your ISP for any doubt about it.
DHCPv6
DHCPv6 enables the Mesh device to obtain an IPv6 address from the DHCPv6 server to access the
internet. It is applicable in the following scenarios:
−
The ISP does not provide any PPPoEv6 user name and password and information
about the IPv6 address.
−
You have a router that can access the IPv6 network.