2.2
Web UI (computer)
This section introduces basic information of the web UI (computer), including:
−
Log in to the web UI
−
Log out of the web UI
−
Change the language
2.2.1
Log in to the web UI (computer)
To log in to the web UI (computer), perform the following steps:
Step 1
Use an Ethernet cable to connect your computer to the LAN port of the primary node.
The LAN port of the primary node may vary with models.
−
For MX3/EX3, connect to the LAN port.
−
For MX6/EX6/MX12/EX12, connect to the LAN2 or LAN3/IPTV port.
−
For MX15 Pro/EX15 Pro/MX21 Pro/EX21 Pro, connect to any of 1, 2 and 3 ports.
Step 2
Start a browser on the computer and enter tendawifi.com in the address bar to access
the web UI.
Step 3
Enter your login password, and click Login.
−
If this is your first login and internet access is not configured, go to Connect your primary node to
the internet.
−
The login password is the one that you specified in Step 5 in Connect your primary node to the
internet. It is case-sensitive. If you forgot the login password, go to Forgot my password.
---End
To Next Page
Loading...
