Tenda MX3 - Advanced

Document version: V1.0
99
Speed
Application
100 Mbps full duplex
Indicates that the WAN port is working at the speed of 100 Mbps, and the port can
receive and send data packets at the same time.
100 Mbps half
duplex
Indicates that the WAN port is working at the speed of 100 Mbps, but the port can
only receive or send data packets alternately.
10 Mbps full duplex
Indicates that the WAN port is working at the speed of 10 Mbps, and the port can
receive and send data packets at the same time.
10 Mbps half duplex
Indicates that the WAN port is working at the speed of 10 Mbps, but the port can only
receive or send data packets alternately.
2.8.10 Advanced
App remote management
The Mesh device can be managed remotely using the Tenda WiFi App. The app remote
management function is enabled by default. You can disable this function as required.
To access the configuration page, log in to the web UI of the Mesh device, and choose More >
Advanced > APP Remote Management.
The following table describes the parameters displayed on this page.
Parameter description
Parameter
Description
APP Remote
Management
Used to enable or disable the app remote management function. It is enabled by
default.