Step 3
Enable the Multicast function.
Step 4
Click Save.
---End
After completing the configuration, you can watch multicast videos on your terminal devices.
WAN parameters
When the Ethernet cable is intact and connected to the WAN port properly, but a prompt
indicating that no Ethernet cable is connected to the WAN port is still shown on the Internet
Settings page, you can try to change the Speed to 10 Mbps full duplex or 10 Mbps half duplex to
solve the problem. Otherwise, keep the default settings.
To access the configuration page, log in to the web UI of the Mesh device, and choose More >
Network Settings > WAN Parameters.
The following table describes the parameters displayed on this page.
Parameter description
To Next Page
Loading...
