Specifies the port number of the Mesh device which is opened for remote
management. You can change it as required.
−
The port number from 1 to 1024 has been occupied by familiar services. It
is strongly recommended to enter a port number from 1025 to 65535 to
prevent conflict.
−
Remote web management can be achieved by visiting “http://WAN IP
address of the Mesh device:Port number”. If the DDNS host function is
enabled, the web UI can also be accessed through “http://Domain name
of the Mesh device’s WAN port:Port number”.
An example of enabling Tenda technical support to access and manage the web UI
Scenario: You encounter a problem in configuring the Mesh device, and the Mesh device can
access the internet.
Goal: Ask the Tenda technical support to help you configure the Mesh device remotely.
Solution: You can configure the remote web management function to reach the goal.
Assume that:
IP address of Tenda technical support: 210.76.200.101
WAN port IP address of the Mesh device: 202.105.106.55
Configuration procedure:
Step 1
Log in to the web UI.
Step 2
Choose More > Advanced > Remote Web Management.
To Next Page
Loading...
