The following table describes the parameters displayed on this page.
Parameter description
Used to enable or disable the UPnP function.
Specifies the address of remote host to receive and send responses.
Specifies the port set on the Mesh device to map to the outer.
Specifies the address of inner host to receive and send responses.
Specifies the host port which needs to be mapped.
Specifies the mapping protocol.
Port mapping
Overview
With this function, you can map an external port to an internal port, so that applications using the
internal port (such as a web server) are accessible from the internet.
To access the configuration page, log in to the web UI of the Mesh device, and choose More >
Advanced > Port Mapping.
The following table describes the parameters displayed on this page.
Parameter description
Specifies the IP address of the intranet server.
Specifies the service port of the intranet server.
Specifies the external port for the internal port to map with.
To Next Page
Loading...
