The following table describes the parameters displayed on this page.
Parameter description
Specifies the current system time.
Specifies whether the system is synced.
Specifies the sync mode of the system time.
−
Sync with internet time: Indicates that the system time is synced with the
internet time. Time Zone must be set when this option is selected.
−
Sync with local time: Indicates that the system time is automatically synced
with the local time on your host, and you do not need to select a time zone.
Required when Sync with internet time is selected for Sync Mode.
It specifies the time zone used for the system time. Select one option as required.
Displayed when Sync with local time is selected for Sync Mode.
It specifies the local time set on your host.
Used to enable or disable the Daylight Saving Time (DST) function. It is disabled by
default.
Required when DST is enabled.
It specifies the start time of DST.
Required when DST is enabled.
It specifies the end time of DST.
Displayed when DST is enabled.
It specifies whether the DST is used.
Firmware upgrade
With this function, you can upgrade the firmware of the Mesh device to obtain the latest functions
and more stable performance. The Mesh device supports one-click upgrade, online upgrade and
local upgrade.
To access the configuration page, log in to the web UI of the Mesh device, and choose More >
System Settings> Firmware Upgrade.
When the Mesh device is connected to the internet, it auto-detects whether there is a new
firmware version and displays the detected information on the page, as shown in the following
figure. You can choose whether to upgrade to the latest version.
To Next Page
Loading...
