Online upgrade
To perform online upgrade on a single node:
Step 1
Log in to the web UI.
Step 2
Choose More > System Settings > Firmware Upgrade.
Step 3
Click Online Upgrade in the line of the node to be upgraded.
Wait until the upgrade completes. Then, access the Firmware Upgrade page again and
check whether the upgrade is successful based on Current Firmware Version
.
---End
For better performance of the new firmware of the Mesh device, you are recommended to reset the
Mesh device to factory settings and re-configure the Mesh device after the upgrade completes.
Local upgrade
To prevent the Mesh device from being damaged:
−
Ensure that the firmware is applicable to the Mesh device.
−
It is recommended to upgrade the firmware by connecting a LAN port to a computer and
performing the upgrade on the web UI.
−
When you are upgrading the firmware, do not power off the Mesh device.
Step 1
Go to www.tendacn.com. Download applicable firmware of the Mesh device to your local
computer and unzip it.
Step 2
Log in to the web UI.
Step 3
Choose More > System Settings > Firmware Upgrade.
Step 4
Click Local Upgrade in the line of the node to be upgraded.
Step 5
Click Select File.
To Next Page
Loading...
