---End
After the setting completes, internet users can visit “Protocol name://WAN port IP address of the
Mesh device” to access LAN resources on the FTP server. If the default internal port number is not
used, internet users need to visit “Protocol name://WAN port IP address of the Mesh device:
External port number” to access the resources on the FTP server.
The address in this example is ftp:// 202.105.11.22. You can find the WAN port IP address of the
Mesh device on the internet connection page.
If you cannot access the server after the setting completes, try the following solutions:
−
Ensure that the WAN IP address of the Mesh device is a public IP address, and the internal port
number you entered is correct.
−
Security software, antivirus software, and the built-in OS firewall of the server may cause port
mapping function failures. Disable them when using this function.
−
Manually set an IP address for the server to avoid the service disconnection caused by the
dynamic IP address.
To Next Page
Loading...
