Configuration procedure:
Step 1
Log in to the web UI.
Step 2
Choose More > IPv6.
Step 3
Enable the IPv6 function.
Step 4
Set Internet Connection Type to DHCPv6.
Step 5
Click Save.
The following message is displayed, indicating that the settings are saved successfully.
---End
Verification:
You can ping an IPv6 website (240c::6666 for example) to check whether the Mesh device accesses
the IPv6 network successfully. The following steps are for your reference.
Step 1
On a computer connected to the Mesh device, press Windows + R to open the Run dialog
box.
Step 2
Type cmd and then click OK to open a regular Command Prompt.
To Next Page
Loading...
