Specifies the bandwidth of the wireless channel of a Wi-Fi network. Please change the
default settings only when necessary.
The bandwidth varies with models. Refer to the product you purchased.
−
20MHz: Indicates that the channel bandwidth used by the Mesh device is 20
MHz.
−
40MHz: Indicates that the channel bandwidth used by the Mesh device is 40
MHz.
−
20/40MHz: Specifies that a Mesh device can switch its channel bandwidth
between 20 MHz and 40 MHz based on the ambient environment. This option is
available only at 2.4 GHz.
−
80MHz: Indicates that the channel bandwidth used by the Mesh device is 80
MHz. This option is available only at 5 GHz.
−
160MHz: Indicates that the channel bandwidth used by the Mesh device is 160
MHz. This option is available only at 5 GHz.
−
20/40/80MHz: Specifies that a Mesh device can switch its channel bandwidth
among 20 MHz, 40 MHz and 80 MHz based on the ambient environment. This
option is available only at 5 GHz.
−
20/40/80/160MHz: Specifies that a Mesh device can switch its channel
bandwidth among 20 MHz, 40 MHz, 80 MHz and 160 MHz based on the ambient
environment. This option is available only at 5 GHz.
WPS
The WPS function enables WiFi-enabled devices, such as smartphones, to connect to Wi-Fi
networks of the Mesh device without entering the password.
To access the configuration page, log in to the web UI of the Mesh device, and choose More > WiFi
Settings > WPS.
−
This function only applies to WPS-enabled Wi-Fi devices. It is enabled by default and cannot be
disabled.
−
Wi-Fi networks encrypted with WPA3 cannot be connected through WPS.
−
The WPS negotiation times out in 120 seconds. The WPS button is disabled during WPS
negotiation.
To connect devices to the Wi-Fi network using the WPS function:
Step 1
Log in to the web UI.
Step 2
Choose More > WiFi Settings > WPS.
Step 3
Click the WPS button in the line of the node to which the device is to be connected.
To Next Page
Loading...
