24-Port Managed Gigabit Switch
destination port for the frame. Check to enable the use of the
Destination MAC Address, or uncheck to disable. By default,
destination MAC Address is disabled.
IP Address
The IP address can be used to calculate the destination port for
the frame. Check to enable the use of the IP Address, or
uncheck to disable. By default, IP Address is enabled.
TCP/UDP Port Number
The TCP/UDP port number can be used to calculate the
destination port for the frame. Check to enable the use of the
Port Number, or uncheck to disable. By default, port number is
enabled.
Aggregation Group Configuration
Group ID
Indicates the group ID for the settings contained in the same
row. Group ID "Normal" indicates there is no aggregation. Only
one group ID is valid per port.
Port Members
Each switch port is listed for each group ID. Select a radio
button to include a port in an aggregation, or clear the radio
button to remove the port from the aggregation. By default, no
ports belong to any aggregation group.
3.5.4.2 LACP Configuration
Please select the left meun as TEG3224T→Configuration→
Aggregation →LACP to enter the following window:
28
To Next Page
Loading...
Need help?
General
