24-Port Managed Gigabit Switch
3.12.4.4 Rate Limit Configuration
Please select the left meun as TEG3224T→Configuration→
QoS→Rate Limiters to enter the following window:
Configure the switch port rate limit for Policers and Shapers on this
page.
Port
The logical port for the settings contained in the same row.
Policer Enabled
Enable or disable the port policer. The default value is
"Disabled".
Policer Rate
Configure the rate for the port policer. The default value is
"500". This value is restricted to 500-1000000 when the
"Policer Unit" is "kbps", and it is restricted to 1-1000 when the
"Policer Unit" is "Mbps"
Policer Unit
Configure the unit of measure for the port policer rate as kbps
or Mbps. The default value is "kbps".
70
To Next Page
Loading...
