24-Port Managed Gigabit Switch
Shaper Enabled
Enable or disable the port shaper. The default value is
"Disabled".
Shaper Rate
Configure the rate for the port shaper. The default value is
"500". This value is restricted to 500-1000000 when the
"Policer Unit" is "kbps", and it is restricted to 1-1000 when the
"Policer Unit" is "Mbps"
Shaper Unit
Configure the unit of measure for the port shaper rate as kbps
or Mbps. The default value is "kbps".
3.12.4.5 Storm Control Configuration
Please select the left meun as TEG3224T→Configuration→
QoS→Storm Control to enter the following window:
Storm control for the switch is configured on this page. There is a
unicast storm rate control, multicast storm rate control, and a
broadcast storm rate control. The rate is 2^n, where n is equal to or
71
To Next Page
Loading...
