ELECTRICAL SYSTEM
10J-35
SECTION 10J. FUSES
FUSE TESTS
The fuses are located in the fuse block mounted on the
right side of the mower frame. A plastic cover protects
the fuses and must be removed for access. The fuses
can be tested as follows:
1. Visually inspect and replace any blown fuse.
2. If the fuse does appear to be blown, check the
fuse as follows:
a. Set the multimeter to the continuity scale.
b. Connect one test lead to each fuse blade
(Figure 10J-1).
Continuity should be available between the
fuse blades. If not, replace the fuse.
Figure 10J-1. Fuse Test
10J
To Next Page
Loading...
