Thermal Dynamics PAK 200 - Page 51

PAK 200
Manual 0-5057 4-9 OP-
Status Code Key (cond)
Status
Code
Message Cause/Remedy
5-1
CANBUS Failure to Acknowledge
fault.
Does not apply to PAK200, if displayed CCM defective.
5-2
CANBUS Off due to
excessive data errors;
Does not apply to PAK200, if displayed CCM defective.
5-3
CANBUS data error warning.
Errors increasing, will soon fault.
Does not apply to PAK200, if displayed CCM defective.
5-4 CCM Message not sent Does not apply to PAK200, if displayed CCM defective.
6-1 CCM Analog Voltage Error Replace CCM
6-2 CCM ADC or DAC error Replace CCM