Thinget XC Series User Manual

Applied Instructions
5-4. Contactor’s Compare Instructions
Mnemonic ¾ Function
LD＝ Initial comparison contact. Active when the comparison (S1)＝(S2) is true.
LD＞ Initial comparison contact. Active when the comparison (S1)> (S2) is true
LD＜ Initial comparison contact. Active when the comparison (S1)< (S2) is true
LD＜＞ Initial comparison contact. Active when the comparison (S1)≠(S2) is true
LD＜＝ Initial comparison contact. Active when the comparison (S1)≤(S2) is true
LD＞＝ Initial comparison contact. Active when the comparison (S1)≥(S2) is true
AND＝ Seri ison contact. Active when parison (S1)＝(S2)is eal compar the com tru .
AND＞ Serial com act. Active when mparison (S1)> (S2) is trueparison cont the co .
AND＜ Serial com act. Active when comparison (S1)< (S2) is trueparison cont the .
AND Serial compari n the comp (S2) is true. ＜＞ son contact. Active whe arison (S1)≠
AND＜＝ Serial comparison contact. Active when the comparison (S1)≤(S2) is true.
AND Serial compari n the comp (S2) is true. ＞＝ son contact. Active whe arison (S1)≥
OR＝ Parallel comparison contact. Active when the comparison (S1)＝(S2) is true.
O Parallel compar Active when the com > (S2) is true. R＞ ison contact. parison (S1)
OR＜ Parallel comparison contact. Active when the comparison (S1)< (S2) is true.
OR Parallel compar Active when the com ≠(S2) is true. ＜＞ ison contact. parison (S1)
OR＜＝ Parallel comparison contact. Active when the comparison (S1)≤(S2) is true.
OR Parallel comparison . Active when the com ≥(S2) is true. ＞＝ contact parison (S1)
Mnemonic & Function
77

Thinget XC Series Specifications

General

Brand	Thinget
Model	XC Series
Category	Controller
Language	English