Thinget XC Series User Manual

Applied Instructions
130
Function & Action
即使使用 X000=OFF 停止执行 TZCP 指令时，M0~M2
仍然保持 X000 变为 OFF 以前的状态。
Compare the two assigned time with time data
z Compare the 3 clock data start from with the two ends on the clock compare bound,
according to the area bound, output the three ON/OFF status starts from
S·
D·
＋1 2 : Assign the compare low limit in the form of “Hour”, “Minute” and “Second”.
＋ 2 : Assign the compare low limit in the form of “Hour”, “Minute” and “Second”.
＋1 ＋2 : Assign the clock data in the form of “Hour”, “Minute” and “Second”.
＋1 ＋2 : According to the compare result, the 3 devices output ON/OFF.
S1·
, ， ＋
, 1， ＋
S1·
S1·
S2·
, ，
S2·
S2·
S·
, ，
S·
S·
D·
D·
D·
The valid range of “Hour” is「0~23」.
The valid range of “Minute” is「0~59」.
The valid range of “Second” is「0~59」.
[TZCP]
16 bits instruction：DIV 32 bits instruction：DDIV
Suitable Models：
XC3、XC5
¾
Word
Device
Bit
Device
The status of the destination devices is ke
p
t
,
even if the TCMP instruction is deactivated.
X Y M S T C Dn.m
D·
D
FD
DM
DX
DY
DS
TD
CD
K/H
S1·
S2·
S3·

Thinget XC Series Specifications

General

Brand	Thinget
Model	XC Series
Category	Controller
Language	English